I mean in your thread :
The
HEADER POS on
START-OFFSET is 200 but the
HEADER POS on
Length is 10 , did u
The
LENGTH of Hash Table on SProtect Example is : 04 00 * 02 00 = 80000 not 400 ?
On BlacklightsC Old Thread
BlacklightsC wrote:
Open Windows Calculator to Programmer mode.
Change to Hex, DWORD.
Start-offset = Header Pos + Hash/Block Pos
Length = Hash/Block Size * 10
Pos and Size must read little-endian
ex. 92 E9 A7 01 -> 01 A7 E9 92 -> 0x01A7E992
nuzamacuxe wrote:
1) START-OFFSET & LENGTH VALUES:
NOTE: Don't forget to set your Windows calculator to DWORD.1.1) To find the START-OFFSET of the HASH TABLE:
HASH POS + HEADER POS (01 A7 E9 92 + 200) = 1 A7 EB 92
1.2) To find the LENGTH of the HASH TABLE:
HASH SIZE * HEADER POS (4 00[400] * 10) = 4000
Here
nuzamacuxe wrote:
1) START-OFFSET & LENGTH VALUES:
NOTE: Don't forget to set your Windows calculator to DWORD.
To find the START-OFFSET of the BLOCK TABLE:
BLOCK POS + HEADER POS (0 + 200) = 200
To find the LENGTH of the BLOCK TABLE:
BLOCK SIZE * HEADER POS (2 94[294] * 10) = 2940
Here
nuzamacuxe wrote:
1) START-OFFSET & LENGTH VALUES:
NOTE: Don't forget to set your Windows calculator to DWORD.1.1) To find the START-OFFSET of the HASH TABLE:
HASH POS + HEADER POS (FF E3 B4 14 + 1C4E00) = 214
1.2) To find the LENGTH of the HASH TABLE:
HASH SIZE * HEADER POS (8 00[800] * 10) = 8000
And here
nuzamacuxe wrote:
1) START-OFFSET & LENGTH VALUES:
NOTE: Don't forget to set your Windows calculator to DWORD.
To find the START-OFFSET of the BLOCK TABLE:
BLOCK POS + HEADER POS (FF E4 FC 16 + 1C4E00) = 1 4A 16
To find the LENGTH of the BLOCK TABLE:
BLOCK SIZE * HEADER POS (4 06[406] * 10) = 4060